Tico Pro-Spotter, Service Manual

Page: 159 / 211

PRO-SPOTTER CAB
TICO Manufacturing
Service Manual 13-5
Figure 13-4: Housing (left side shown)
4. Remove nut (5) and disconnect linkage (6).
5. Remove lock nuts (7) and washers (8). Set cab
leveling valve (9) aside.
6. Install identification tags and disconnect air line (10)
at housing (11).
7. Apply alignment marks to housing and cab frame to
aid when installing.
8. Remove cap screws (12), washers (13), lock nuts
(14), and housing.
Figure 13-5: Cab Air Bag Striker
9. Remove lock nuts (15) and cab air bag striker (16)
from cab air bag (17).
Figure 13-6: Housing (upper)
10. Remove nuts (18) and cab air bag from housing.
11. Repair or replace components as necessary.
Inspection
• Clean all parts of dirt and debris.
• Inspect air lines, fittings, and connections for leaks,
holes, cracks, and loose connections. Replace parts
found to be unserviceable.
• Check all threaded components for damaged or
stripped threads. Repair light damage with thread
chasers. Replace parts found to be unserviceable.
Installation
Installation is the reverse of the removal procedure.
• Check cab air bag alignment with cab latch. (See
“Adjustment” on page 13-3.)
5 Nut 10 Air Line
6 Linkage 11 Housing
7 Lock Nut (2 used) 12 Cap Screw (4 used)
8 Washer (2 used) 13 Washer (8 used)
9 Cab Leveling Valve 14 Lock Nut (4 used)
5
TPS-151
6
8
7
9
10
11
12
14
13
11 Housing 16 Cab Air Bag Striker
15 Lock Nut (2 used) 17 Cab Air Bag
11 Housing 18 Nut (2 used)
11
TPS-152
15
17
16
11
TPS-153
18