Tico Pro-Spotter, Service Manual

Page: 157 / 211

PRO-SPOTTER CAB
TICO Manufacturing
Service Manual 13-3
INTRODUCTION
The purpose of the CAB section is to provide service and
maintenance personnel with guidance on the proper
procedures for removing and replacing of the various cab
components and the cab hydraulic tilt system on the
TICO Pro-Spotter terminal trucks.
The TICO Pro-Spotter terminal trucks have been
engineered for quick and efficient servicing while
minimizing downtime.
Service and maintenance personnel should only remove
components deemed necessary for the service or
maintenance procedure being performed.
For additional information, please contact TICO factory
support. (See “CONTACT TICO SUPPORT” on
page 0-15.)
CAB AIR BAG
Adjustment
See Figures 13-1 and 13-2.
NOTE
Procedure is written for the right side cab latch. Left side
cab latch procedure is similar.
1. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)
Figure 13-1: Lock Bar
2. Raise cab completely and allow it to settle into detent
position 1 (full open) (1) of the lock bar (4).
1 Detent Position 1 (full open) 3 Detent Position 3 (minimum
open)
2 Detent Position 2 (half
open) 4 Lock Bar
TPS-083
1
2
3
4