Tico Pro-Spotter, Service Manual

Page: 46 / 211

2-2 Service Manual
TICO Manufacturing
PREVENTATIVE MAINTENANCE PRO-SPOTTER
INTRODUCTION
The purpose of the PREVENTATIVE MAINTENANCE
section is to provide service and maintenance personnel
with the required service procedures based on hour
usage intervals to properly maintain TICO Pro-Spotter
terminal trucks.
The TICO Pro-Spotter terminal trucks have been
engineered for quick and efficient servicing while
minimizing down time. The hydraulic system is
responsible for fifth wheel boom and power steering
operation.
Service and maintenance personnel should inspect the
entire hydraulic system frequently for leaks, loose fittings,
or damage.
For additional information, please contact TICO factory
support. See “CONTACT TICO SUPPORT” on
page 0-15.
DAILY PRE-OPERATION
CHECKLIST
The Daily Pre-Operation Checklist should be completed
by any operator or service and maintenance personnel
prior to operating the machine.
Identified areas of concern should be addressed by
qualified personnel only. References to procedures
documented within this manual or additional sources of
information have been provided where applicable.
For additional information, please contact TICO factory
support. See “CONTACT TICO SUPPORT” on
page 0-15.
Cab Interior Checks
• Clean all windows if necessary.
• Check all rear view mirrors. Adjust and clean if
necessary.
• Check windshield wiper for proper operation.
• Check steering system for any binding. Make sure
steering effort is smooth and tight.
• Check transmission shift lever for any binding.
• Check horn(s) for proper operation.
• Check boom control lever for proper operation.
• Check accelerator for proper operation; should
operate smoothly and without any binding.
Exterior (Cab Down) Checks
• Check all fluid levels: engine oil, hydraulic oil,
coolant, and diesel exhaust fluid (DEF).
• Inspect trailer electrical cable and trailer air lines for
damage.
• Start engine and check transmission fluid level with
parking brake applied and transmission shift selector
in “neutral”.
• Check all lights for proper operation: headlights, turn
signals, brake lights, hazard lights, and marker lights.
• Check and fill fuel tank.
Exterior (Cab Up) Checks
• Check cab hold down latch and the air suspension
unit for proper latching.
Under Vehicle Checks
• None at this interval.
Chassis Checks
• Check tires for damage and proper inflation.
• Drain any moisture from air tanks.
• Check cab and frame for any structural damage or
cracks.
• Ensure that all steps, walkways, and handholds are
installed and in good working order.
Lubrication Checks
• Check fifth wheel grease.