
TO DISMANTLE SNAP RING TYPE
To remove sliding joint from splined shaft, unscrew the dust cap and pull back the
cork washer.
1.
Clean enamel from snap rings and top of bearing races. Remove all snap rings by
pinching ears together with a pair of pliers, and prising with a screw driver. If ring
does not snap out of groove readily, tap end of bearing race lightly to relieve the
pressure against ring. Support the shaft and with the yoke lug on top, tap yoke arms
lightly with a soft hammer.
2. Top bearing should begin to emerge, turn shaft over and finally remove with fingers.
3.
If necessary tap bearing race from inside with small diameter bar, taking care not to
damage bearing race.
4-2
Summary of Contents for SPRITE NIMBUS
