Thrane&Thrane TT-3064A, User Manual

Page: 131 / 152

Appendix K - AT Command Set
15Oct99
Page K-1
A A
PPENDIX PPENDIX
K K - AT C - AT C
OMMAND OMMAND
SS
ET ET
The commands listed below are described without the preceding
‘AT’ letters.
Basic AT Commands Basic AT Commands
When a command that requires a value is given without a value the
value is assumed to be 0, e.g. ATH is similar to ATH0. The factory
setting values for the commands are printed in bold text.
A Manual answer of incoming call.
For automatic answering of a data call refer to the
description of the S0-register. Other commands
specified after the A command will not be executed.
AT Appears at the beginning of every command line.
If it is specified without any successors the Capsat®
Telephone will respond with an ‘OK’ result message.
Can be used to check if you have contact with the
Capsat® Telephone from the DTE.
D_ Dial command.
Only the digits 0-9 following this command will be
bypassed in the dial string. The characters ‘A’-’D’
can be specified for compatibility with ordinary data
modems but are not used.
P Pulse dialling.
Not used but can be specified for compatibility with
ordinary data modems.
T T Touch-tone dialling.
Not used but can be specified for compatibility with
ordinary data modems.
S=<n> Short number from handset phone book.
This command will dial a phone number stored in
the phone book in the handset. The phone number
is identified by the short number <n>, max. 2 digits.