TT-3608G Printer Unit
TT-3608G Printer Unit
TT-3608G Printer Unit
TT-3608G Printer Unit
System Installation
System Installation
System Installation
System Installation
25Jul00
25Jul00
25Jul00
25Jul00
Page
Page
Page
Page 3-43
3-43
3-43
3-43
3.8.1
Configuration.
Before installation of the TT-3608G, configuration of Arcnet ad-
dress should take place.
The Printer Unit Arcnet address is configured by setting an 8 po-
sition DIP switch located under the paper inlet. To set operating
parameters remove paper and turn off power. In Table 29 the
possible DIP switch settings are listed.
It is important to observe that all devices connected to the same
transceiver must have different address settings. If this is ignored,
the Arcnet will not operate properly. Please notice that if a “net-
work problem” info box is displayed on the message terminal the
Arcnet is not configured properly.
Note: Operating parameters are only read at power-up or softre-
set so changes in operating parameters will not change operation
until a power-cycling or softreset is performed.
