LFE1220W-US, -EU, and -UK Laminar Flow Enclosures
Chapter 3: Installation
Rev A April 2021
Page 35
38.
Fit the gussets from step 36 to the frame as shown below.
Align the heads of the hammerhead screws with the slots in the extrusion then push the heads inside.
Once inside the slot, turn the screws clockwise such that the slot on the end of the hammerhead screw is
perpendicular to the slot in the extrusion as shown below, use a screwdriver as necessary. Tighten the nuts using the
10 mm spanner (AM) supplied.
Warning
This step will require the use of stepladders or step stools. These should be positioned close to the frame to
prevent overreaching.
Figure 35 Fitting the Corner Gussets
Summary of Contents for LFE1220W-EU
Page 68: ...www thorlabs com...
