THORLABS BC207UV, Operating Manual

Page: 172 / 181

BC207 Series Chapter 10: Appendix
Page 165
MTN026962-D02
10.7 Initial Settings
When the BC207 Series is used first time with the BEAM software, the following initial settings
are applied:
Parameter Default value
Region Of Interest Full Size
Tab Beam Profiler Parameter
Wavelength 635nm
Filter Wheel Selection [dB] No Filter (0 dB)
Auto Exposure Control ON
Gain 1.0 (minimum)
Tab Corrections
Hot Pixel Correction ON
Power Correction OFF, factory calibration active
Ambient Light Correction OFF
Tab Trigger
No Trigger (selected)
Software Trigger OFF, 50% min AD saturation
Hardware Trigger OFF, Rising Edge
Single Pulse 100ms Target Delay
Repetitive Pulses 1.000kHz Rep. Rate
10.8 Compatibility with Older Hardware
The Beam Software is downwards compatible with the following discontinued hardware com-
ponents:
·
BC106N-UV, BC106N-VIS (Camera Beam Profiler)
Electrical connections and mechanical setup should be carried out as described in the appropri-
ate documentation to this hardware, while operation is described in the manual on hand.
Older documentation can be downloaded from the Thorlabs Manual Archive at www.thor-
labs.com/manuals.cfm . Open this page and enter the desired item number; be careful about
correct spelling.