THOR Palazzo 2015, Owner'S Manual

Page: 99 / 150

98
Operation Mode
The first line shows the status of the battery charger. It will show one of the following:
BatChargeNormal: Under complete battery charger control.
BatChargeReduced : An owner activated appliance would have caused a circuit
breaker to trip but instead the Bat Charger Rate has been
reduced.
Reducing the battery will be the first thing that PCS will attempt in order to reduce
overall RV power. Battery charge may not be reduced if the battery is low or the
inverter is on the Line 1 Circuit Breaker and the Overload is on Line 2 only.
The second line shows the status of the inverter. It will show one of the following:
InverterNorma l: Under complete inverter control.
InverterAssist : The PCS is requesting that the inverter assist by temporarily
generating 120VAC power from the batteries.
InverterAssist12A : The end of this line shows the amount of 120VAC current that
the inverter is supplying.
InverterAssistDeny : The inverter can not assist at this time, for one of many
inverter reasons, i.e. Battery Low, Over-current, etc.
The last line shows if any loads have been shed to prevent circuit breaker tripping.
depending on the model RV, there can be up to 7 loads that PCS can control.
This Screen gives the general information about
Load Status.
Water Heater OFF 11A : Indicates that the water heater power has been
temporarily turned OFF and that the current at the instant the Water Heater was
turned off last was 11amps.
Refrigerator ON 7A : Indicates that the Refrigerator has power. Again the 7amps
of current is NOT the present current draw, but rather the current at the instant the
Refrigerator was last turned off.
A/C #2 ON : Indicates that the A/C #2 has power. Since there is no current displayed,
this load has not been turned OFF since the battery has been reconnected and
12V power applied to PCS. PCS has never had a chance to “learn” the current. The
current displayed is re-learned every time that the load is turned OFF.
Load Status
Where the last screen gave general information
about all the controlled loads, the next two screens
give detailed information about the status of each
load under PCS control.
Electrical Systems