82
SYSTEM Button
The SYSTEM button is used to put the thermostat into either heating, cooling or off.
When in OFF, the system will not operate any heating or cooling appliances.
However, the LCD display will still show the room temperatures in each zone.
When in HEAT, the system is in heating. The heating appliance selected will
operate when the zone room temperature is one degree below the desired setpoint
temperature. The heating appliance will continue to run until the zone room
temperature is one degree above the desired setpoint temperature.
When in COOL, the system is in cooling. The cooling appliance connected in the
particular zone will operate according to the mode the zone is set to.
ZONE Button
This button allows the user to toggle through the different area zones.
By pressing the ZONE button the user toggles through each zone. When the system
is first powered up, it determines how many zones are in the system and only
displays the detected zones.
MODE Button
By pressing the MODE button, the user toggles through the different modes for the
system. When in cool, the thermostat will toggle through the following modes: Cool
Auto, Cool High, Cool Low, Fan High, Fan Low and Off. When in heat, the thermostat
will toggle through the following modes: Gas Heat, Heat Elec and Off. However, this
will only happen if the system has both gas and electric heat in a zone. For instance,
if a system only has an air conditioner and a gas furnace in a zone, then when set to
heat, the user will only be able to toggle through Gas Heat and OFF because there
is not electric heat available. Furthermore, if the system does not have an appliance
connected in a zone, then the user will not be able to toggle modes in that zone.
Set Temperature
1. Use the SYSTEM button to select either COOL or HEAT. The current room
temperature for that zone will display.
2. Press the MODE button to select the operation your desire.
3. Press either the UP or DOWN arrow once to place the thermostat in the SET
mode. At this point the thermostat displays the current setpoint for the displayed
zone. (SET will show on the LCD display).
4. Press the appropriate arrow button to change the set point temperature to the
desired setting. Each press of the up arrow will increase the setpoint temperature by
one degree. Each press of the down arrow will decrease the setpoint temperature by
one degree.
5. Pressing ZONE button to toggle to the next zone or letting the thermostat sit idle
for a few seconds will store the temperature setting in the thermostat memory.
6. This process should be done for each zone.
Set Fan Speed for Cooling Mode
1. Use the SYSTEM button to select cool option.
Summary of Contents for Palazzo 2015
