62
Note:
Make sure you close the J-lounge or return any sofa to its
original seating position before retracting the slide rooms to
avoid damage.
The euro recliner, where equipped, has controls on the left side of the chair that
release the footrest. To recline, sit down, pull the recline lever or switch to release
the footrest. Since a seat belt is not provided, do not use the euro recliner while in
transit.
Booth
The dinette will seat four people. Storage and/or various systems components can
be accessed from above by removing the seat cushions and lifting the seat supports.
Free Standing
Since the free standing dinette chairs are not secured to the floor, and not equipped
with seat belts, they should not be occupied while the motorhome is in motion. These
chairs should be stored securely while the vehicle is in motion.
Pedestal
The dinette can also be converted into an additional bed if required. To convert, lift the
table top off of the two support posts. Remove the support posts from the floor and lay
them down between the seats. Insert the table top between the seats on the ledges
provided. Loosen the seat cushion from the Velcro fasteners and slide each together
to form the bed. Reverse this process when reconverting to the dinette configuration.
Buffet
Since the free standing dinette chairs are not secured to the floor, and not equipped
with seat belts, they should not be occupied while the motorhome is in motion. These
chairs should be stored securely while the vehicle is in motion.
Reclining Back
A control lever on the left or right side of seat controls the angle of the back rest. Lift
up on the lever, lean back to position seat and then release the lever to lock the back
rest in place. To return the backrest to upright position, lift up on the control lever. It
will automatically return to its normal upright position.
To prevent damage, be sure to
return the seat back to it’s upright position before operating the slide out rooms.
Seat Swivel
A control lever on the side of seat controls the swivel function. Push the lever forward
to release the detent on the swing mechanism. Once the lock is released, the seat
may be rotated either left or right.
Forward And Back Adjustment
The forward and back sliding action is controlled by a lever on the lower left side of
the seat. To adjust, pull the lever outward to release the latch, and slide the seat to the
desired position. Make sure the seat locks into the position you have selected.
Arm Rests
Arm rests can be rotated up and out of the way when not required.
Note:
It may be necessary to adjust the sliding position of the seat
and the tilt of the back, to enable the seat to be rotated
without obstruction from sidewalls or items to the rear. Some
models do not allow complete seat rotation.
Controls and Operations
EURO RECLINER
DINETTE
CAPTAIN’S CHAIRS
PILOT AND CO-PILOT SEATS MUST BE LOCKED IN
A FORWARD FACING POSITION WITH SEAT BELTS
FASTENED WHILE THE MOTORHOME IS IN MOTION.
Avoid seat rotation while in transit.
Summary of Contents for Palazzo 2015
