93
Menu Pushbuttons
SHORE:
This pushbutton allows you to set the appropriate breaker size for the
incoming utility/shore power and is used to control the amount of AC amps
the battery charger uses from the HOT 1 IN input.
AGS:
This pushbutton allows the networked Auto Generator Start controller to
be configured to specific system preferences and check status of the AGS,
when connected.
METER:
This pushbutton provides meter information on the inverter/charger system.
SETUP:
This pushbutton allows the inverter/charger to be configured to your specific
system preferences.
TECH:
This pushbutton allows you to access menu selections that can help service
personnel with troubleshooting and also allows the factory default setting to
be restored.
Rotory SELECT Knob
The Rotary SELECT Knob is similar to a dash radio knob and is used to easily view
and select various menu items and settings displayed on the LCD screen. Turn the
rotary knob clockwise and counterclockwise to view the different menu items and the
available charger and inverter settings. Push the SELECT knob to select a menu item
or to save a setting once they are displayed on the LCD screen.
Note:
All adjustable inverter/charger settings, except for the SHORE:
Shore Max and SETUP: 08 Screen Setup settings – which revert
back to default, are saved in nonvolatile memory and are preserved
until changed. This is true even if an inverter reset is performed, or if
all power to the remote or inverter is removed.
Note:
The LCD display can be refreshed by holding down the SELECT
knob for 10 seconds.
CAUTION
An accessory that is networked to the inverter may have
adjustable settings that revert back to default if all power
to the inverter is lost. Refer to the operation manual for
the particular accessory to determine if any setting for
the accessory is affected.
Operation - Inverter
Mode
CAUTION
If you have critical loads and are in Inverter Standby, do
not press the ON/OFF INVERTER pushbutton to turn the
inverter function off. If the green INV LED is off, inverter
power will not be available to run your critical loads if
the external AC power is interrupted.
Turning the inverter on:
Press the ON/OFF INVERTER pushbutton to activate the
inverter function. The inverter will either be actively
inverting by using power from the batteries to power the AC
loads, or will be searching for a load by using very little
power from the batteries if in Search mode. The green INV
LED will be on when the inverter is actively inverting and
will flash while searching.
Turning the inverter off:
While the inverter is actively inverting or searching,the
ON/OFF INVERTER pushbutton can be pressed to switch
the inverter function off. This will turn the green INV LED
off.
Electrical Systems
Summary of Contents for Palazzo 2015
