English
17
Subtitle language
:
Set the language for the subtitles, if available, subtitles are displayed in the
selected language.
Volume settings
:
Here, you can set whether channels should use a
unite
volume control or if
this should be controlled seperately
Per Service
. Try to find out which setting
works best for you.
NOTE:
DVB subtitles on Astra 19.2 are currently available on different German
channels: Das Erste HD, ZDF HD, 3sat HD, arteHD, WDR HD and other
popular channels. If you switch the
Subtitles Display
to
On
, the according
subtitles will be displayed automatically in case of availability for this
channel/movie. When the setting is
Off
, subtitles can be temporary
opened. Further information about subtitles can be found on the
broadcaster's own videotext pages or websites.
7.3.2 System Settings
In this menu, you can adjust the video parameters according to the connected TV, while general
settings are also available.
HDMI Resolution
:
This allows you to set the resolution for your HDMI output. If your TV does
not support the newly set value, the screen turns black. In this case, wait for
about 10 seconds and do not press any buttons on the remote control, then
the value will automatically be reset to the previous one.
Aspect Ratio
:
Set the screen format that corresponds to that of the connected TV (4: 3 or
16: 9).
Aspect Conversion
:
Set the image conversion as required.
When a TV is connected with the aspect ratio of 4: 3, the optimal mode
is Letterbox. A video in the 4: 3 format is not adjusted in this mode, but a
video in the 16: 9 format is adjusted so that it is reproduced completely and
without distortion (there are black horizontal bars above and below the
picture). When a TV with aspect ratio 16: 9 is connected, the optimum mode
is 16: 9. A video in the 4: 3 format is reproduced with this setting without
distortion (however, there are black vertical bars on the left and right of
playback). A video in the 16: 9 format is displayed without image adjustment
and covers the entire screen. Note that it is also possible to set the format
via the menu of your TV (depending on your TV model).
HDMI Audio Output
:
Here you can set the setting for the digital audio output via HDMI. Press
the
t
u
buttons to select between
BitStream
and
PCM
. If a TV set that
supports Dolby® Digital * is connected, use the
BitStream
setting. If this is
not the case, use
PCM
.
S/PDIF Audio Output
: Here you can set the digital audio output via the coaxial S/PDIF. Press the
t
u
buttons to select between
BitStream
and
PCM
. If a home theater,
amplifier, or similar is connected that supports Dolby® Digital *, use the
BitStream
setting. If this is not the case, use
PCM
.
OSD Transparency
:
You can set the transparency in this menu. You can choose between
different values and
Cover
Banner Time Out
:
Here you can adjust how long the infobanner is displayed.
Recent channel list
Here, you can change the function of the
9
button, by default set
On
, which
allows you to open the
Recently watched channels
list using
9
in TV mode
to access up to 30 of the most recently watched channels. If you set
Off
, the
button will only change between the 2 last watched channels.
Deep Standby After
:
This function switches the receiver into a power-saving mode (Deep Sleep)
after switching it off (into standby) within the set time. Available settings are:
5 minutes
,
15 minutes
,
30 minutes
,
1 hour
,
3 hours
and
Off
. The receiver
consumes less power than in standby mode. To power up from deep sleep
mode, it takes about 35 seconds.
