English
5
-
If you are going to use external USB HDD (Hard Disk Drive) please consider that it might be the
case that the power specifications exceed the supported output of your receiver (5 V/500 mA). If so,
please connect your USB HDD to an according external power adapter.
-
STRONG cannot guarantee compatibility with all types of USB storage devices.
-
It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver. STRONG
will not take responsibility for any loss of information or circumstances caused by loss of information.
-
For a proper performance with this receiver your USB device must be formatted to FAT32.
-
Playback of files cannot be guaranteed although extensions are listed, as it depends on the codec,
data bit rate and resolution (all MPEG codec formats are supported).
2.0 YOUR RECEIVER
2.1 DEFAULT PIN-CODE: 0000
2.2 Front Panel
Fig. 1
1.
LED Display
Displays channel number in TV mode and the time in Standby
mode
2.
IR Sensor
Receives the RCU commands.
3.
Indicator LED
GREEN indicates that the receiver is currently ON, RED indicates
that the receiver is currently in Standby mode.
4.
STBY/ON
Switches the receiver ON or into Standby.
5.
USB
To connect your USB storage device for multimedia functions or
software update.
2.3 Rear Panel
Fig. 2
1.
SAT IN
To connect to the LNB of your satellite antenna for reception of
satellite broadcast signal.
2.
IR
To connect the separately available IR extender.
3.
Ethernet
To connect to to your home network via switch, router or modem.
4.
HDMI
To connect to the HDMI input of your TV set using a good quality
HDMI cable.
5.
S/PDIF (coax.)
To connect to a digital amplifier or home theatre set.
6.
TV SCART
To optionally connect to your TV set using a SCART cable.
7.
Power adapter
To connect to the original included main power adapter (Input 100
~240 V 50~60 Hz/ Output 12 V DC
).
2.4 Remote Control
Fig. 3
1.
q
Switches the receiver On/Standby
2.
!
Mutes audio output of the receiver in every mode incl. videotext,
the symbol will not be shown within menu mode
3.
0~9
Channel selection or value input
4.
TV/R
Toggles between TV and RADIO mode
5.
No function
6.
FAV
Opens the favourite list selection if previously configured
7.
9
Opens the recently watched channel list or switches between the
two last previously watched channels*
8.
AUDIO
Opens the list of audio languages
9.
INFO
Shows the actual channel information (2x event info, 3x technical
info)
10.
EPG
Opens the EPG (Electronic Programme Guide) in TV mode
