14
After choosing the desired settings, press
OK
to start the channel search, or press
to exit the menu
without scanning.
* Only available if more than one satellite has been setup.
NOTE:
Network Data/NIT Table (Network Identification Table): This function allows
you to search for the NIT data of the corresponding satellite to receive
newly appeared channels. Please consider that unlike Astra 19.2 or HOT
BIRD 13° some satellites do not offer this function or only support it partly.
If you have any questions, please contact your dealer or the service/
service hotline.
NOTE:
If you want to add or edit parameters for a transponder, we
recommend verifying it by consulting websites like: www.lyngsat.com;
www.kingsofsat.net or you can refer to professional journals.
7.1.4 1 Edit, add or delete transponders
In this submenu, you can edit transponders. Use
pq
to navigate.
Frequency
:
Use the
0~9
buttons to enter the desired/changed frequency.
Symbol Rate
:
Use the
0~9
buttons to enter the required symbol rate.
Polarization
:
Use the
t
u
buttons to change the polarization.
Use
pq
to select
Save
to accept or
Cancel
to discard the changes.
If you have selected a specific transponder from the list and want to delete it, use the
YELLOW
button
and confirm the message with
OK
.
7.1.5 Channel list selection
In this menu, you can select any of the four available channel lists without the necessity of a
Factory
Reset
.
This menu is structured almost the same as the
first time installation
, for details please see chapter
4.3 Channel list selection
and
4.4 Regional Channels
. Only the confirmation of the list is done with
OK
here. The previously selected regional channel is already marked, but you can also select another
one, of course. Please note that done changes or added channels of the previous channel list as well
as favourites will be lost.
NOTE:
The
simpliTV list
contains channels in the sequence and numbering of
the broadcaster. Added/additional channels which are not included in
the list, will be listed from channel number 400 and cannot be edited.
The channels can be edited in
My TV List
, see chapter
7.2.1 TV Channel
Manager
7.1.6 Factory Reset
The factory reset will set the receiver back to the default settings. All saved channels and settings will
be lost!
To reset the receiver, enter your PIN-Code (
DEFAULT
PIN-CODE
:
0000
). Use
t
u
to select
OK
to
perform the reset or
Cancel
to return to the menu. After the factory reset the receiver will start within
the
First Time Installation
.
WARNING:
A factory reset will permanently delete all your personal settings, channels
and timers. Please consider this before you perform a factory reset.
However, you can make a backup of your data to save your satellite,
transponder and channel lists in advance, please read chapter
7.5.3
Database backup to USB device
for more information.
