English
9
videotext mode.
P+/P-
enables you to scroll page wise in all lists, which allows you to select channels
or other items as conveniently as possible.
To open the channel and programme* information, press the
INFO
button in viewing mode. In this
state it is possible to use
t
u
to display channel and programme information about other channels
without switching channels, but however in this mode you can also switch to the selected channel
by pressing
OK
. Press
INFO
twice to display detailed programme information of the current or next
programme. For the current programme information use
t
u
to change between the current and
next event information. In the respective programme information you can use
P+/P-
to scroll if
applicable. If you press the button a third time, technical details of this channel will be displayed. Press
INFO
or
to close the information.
* Programme information are displayed in case of availability. Availability depends on the broadcast.
Note:
5 min after switching the receiver into Standby it will enter the deep sleep
mode. Within this time the receiver is able to start up quickly. Starting up
from deep sleep takes approx. 35 seconds.
6.0 OPERATION
In viewing mode, several features are available to make watching TV a true pleasure. This chapter
describes these features. Please also read chapter
7.0
to get familiar with the menu of your new
receiver.
6.1 Changing channels
Your new receiver is equipped with three ways to change channels.
1. Via direct access
2. Via the channel list
3. Via the
CH+/CH-
or
pq
buttons
4. Via using the
9
button
6.1.1 Direct access
To gain direct access to a certain channel, simply input its number with the
0~9
buttons on the
remote control. Channel numbers can be up to four digits long. Entering a number with less than four
digits is possible. After entering the channel number just wait a few seconds or press
OK
and your
receiver will switch to the selected channel.
Note:
When using the
simpliTV List
some channel numbers may not be
assigned or present in the list. Channels which have been searched
manually or been added personally (e.g. when you had installed another
list before installing the
simpliTV List
) will be assigned from channel
number 400 onwards.
6.1.2 Channel list
Press
OK
in viewing mode to display the channel list. In the header section the corresponding name
of the selected channel list will be displayed. Use
pq
inside the channel list to highlight your channel
of choice and press
OK
to switch to the highlighted channel.
The channel list is equipped with a filter function to make it easier to find your favourite channels.
While in the channel list, press
RED
. An alphabet banner will now be displayed. Use
pq
or
P+/P-
to
select the first letter or number of the channel you wish to filter for and press
OK
or
t
to change
to the filtered list. All channels, beginning with the chosen letter, will now be listed at the left side
(ascending order by channel number). Then use the buttons as usually to select the desired channel.
Afterwards, the normal channel list is displayed again. To quickly switch between your preferred
channels, use the
9
button to display the list of
Recently watched channels
.
The following buttons are available in the channel list and in viewing mode:
TV/R
:
Toggles between TV and radio channels, in channel list changes the list
mode.
