maInmEnU
P13
English
Set Limit
: Press
ok
to open this sub menu for setting up the maximum position
of you dish. This is needed if your dish will touch a wall and can be
damaged.
goToXset-up
In this menu you can set your geographical location if you use a motor and it supports GOTO X.
Press
ok
to open the list of available satellites and chose the desired one with the
tu
buttons.
Your longitude
: Use the
0~9
buttons to enter the values of your longitude. Press
ok
to
confirm the value.
Your latitude
: Use the
0~9
buttons to enter the values of your latitude. Press
ok
to
confirm the value.
GOTO
: Press
ok
to go to the position. Press
EXIT/soRTIE
and select
Yes
to
store and confirm the selection.
Center Position
: Press
ok
to turn the motor to the central position of 0 degrees. This is
only needed 1 x time to adjust the dish the first time.
7.1.2Channelsearch
Use this menu to perform an automatic, network or transponder channel search or to search
on all satellites that have been setup. Use
pq
to highlight an item and
tu
to change settings.
Below the settings you can find the search method selection.
Antenna
: Here you can change the antenna port with
tu
if you have configured
more than one satellite.
Satellite
: Here you will see the satellite that is assigned to the antenna in above, you
can only see the satellite(s) which has/have been setup in the
Antenna
Setup
menu before.
Transponder list
: By pressing
tu
you can change between the transponders referring to
the selected satellite, you can also press
ok
to list and select with
pq
or
Pg±
. Afterwards press
ok
to choose. Press
RED
to
Edit TP
, with
gREEn
you can
Delete TP
and with
blUE
you can enter data for a new
transponder
Add TP
.
Scan Mode
: Here you can decide which channels you want to scan for: Either scan
all channels
FTA & $
, for Free-To Air only
FTA
or use
CA
to scan for
scrambled channels only.
Channel Type
:
TV & Radio
will scan for TV and radio channels,
TV
for TV channels only
and
Radio
for radio channels only.
After you have adjusted the settings for the preferred scan process, move to
Scan selected
satellite
with
pq
and then select the search method with
tu
.
You can select between following procedures:
Scan selected satellite
:
Will scan the selected satellite under above given circumstances.
Search TP
: Will scan the selected transponder under above given circumstances.
Network Search
: Will scan the selected satellite under above given circumstances, but will
scan for new appeared transponders there.
Search All Sat
: Will scan the setup satellites under above given circumstances.*
Fast Scan
: Will rescan the channel list supplied by the operator that you have chosen.
Fast Scan
is only available on Astra 23.5 satellite.
When all settings have been made, press
ok
at the preferred scan method to start this scan
process or
EXIT/soRTIE
to quit without scanning. All newly found channels will be stored at
the end of the channel list.
*Only available if more than one satellite has been setup.
noTE:
NIT (Network Identification Table): This option will scan the NIT table of the satellite and
allows you to receive newly appeared channels. Please consider that some satellites do not
offer this function. Please check with your local dealer.
