THOMSON THS812, User Manual

Page: 17 / 27

P14
maInmEnU
noTE:

When you want to add technical data for a new transponder we recommend verifying it
by consulting websites like: www.lyngsat.com or www.kingofsat.net or you can refer to
professional journals.
7.1.3systemsettings
Use the
System Settings
menu to configure settings for language, audio, video, look and feel
of your receiver. Choose a setting with
pq
and press
ok
to list the possibilities or use
tu
to
change the value of the highlighted setting. Please also read the displayed instructions for each
screen carefully. They will help you to adjust the settings correctly and easily.
Language
: Here you can change the language for the On-Screen-Display, use
tu
to select your preferred language. It affects the menu language of your
receiver so all menus and messages will be displayed in the chosen
language.
Video Setting : Select the connection to your TV set. Either Scart or HDMI can be
selected via
tu
. Press ok at the used connection to open the settings
for it.
Audio Output : Here you can adjust the settings for your digital audio output. Press
tu
to
choose between BitStream and PCM . If a device that can decode Dolby
Digital is connected, use the setting BitStream . If this is not possible, use
PCM .
Audio language : Press ok to open the setting. The most important audio languages are
displayed.
Start up channel In this menu you can select your start up channel. Select Last watched ,
if your TV shall start with the last viewed channel before the receiver
switched off. To switch on with a specific channel, select
Fixed Channel
by pressing
tu
. Press
ok
and
ok
again to continue. Press
pq
or
Pg+
/
Pg-
to scroll in the list and confirm your selection with
ok
.
Banner display time
:
Defines the time for displaying the information banner. Press
tu
to
choose between
1 sec
~
20 sec
.
OSD transparency
: Defines the transparency of menus and banner. Press
tu
to choose
between 25% , 50% , 75% and fifty-fifty .
When all settings have been made, press EXIT/soRTIE to leave the System Settings menu.
When returning to viewing mode the receiver informs with a message that it saves your settings.
7.1.3.1hDmI
In this submenu you can set following parameters:
TV Ratio
:
16:9
or
4:3
, depending on the kind of your TV set.
Conversion : Letterbox, PanScan or Combined , to choose the preferred picture format.
Video Output : Only selectable for Scart
Resolution : 576p, 720p or 1080i , to adjust the optimum resolution your TV set
supports.
HDCP : ON or OFF, please see the note below.
noTE:
 HDCP (High Definition Content Protection) is set to ON per default as nowadays all TV sets
with an HDMI connector support HDCP. If you have problems with the HDMI connection you
can use the Scart setting to deactivate HDCP, which will allow watching via HDMI without
problems. Consider that movies which are broadcasted with an extra content protection
might not be shown when HDCP is set to OFF.
7.1.3.2sCaRT
In this submenu you can set following parameters:
TV Ratio
:
16:9
or
4:3
, depending on the kind of your TV set.