60
value range is
0
through
10
. A value of
1
will display at the highest position vertically and
10
at the lowest.
Press the
A-D
button to go to the second
STATUS
setup page and change the OSD positions of
SOURCE
and
SRATE
(sample rate).
Note
: It is possible to have conflicting results if more than one item is displayed on the same line.
LCD Brightness
Each
INPUT SELECT
button can have a different LCD brightness assigned to it. Pressing button #
6
in figure 21
(page 49) allows the user to change the default brightness from
OFF
to
FULL
(brightest) in four steps. Any changes
made to this parameter are reflected the next time that
INPUT SELECT
button is pressed. If this value is set to
OFF
,
and the LCD is off, pressing any button except
DISPLAY
will automatically brighten the LCD to the maximum level. If
the button pressed is not another
INPUT SELECT
or function button, then the LCD will revert back to its default
brightness in
X
seconds.
X
represents the
TIME
parameter value in the
SETUP
/
INP Page 1
/
OSD
sub menu. If the
LCD is on but not set to
FULL
, pressing any button other than another
INPUT SELECT
button will allow the LCD to
remain at its default brightness, with the exception of pressing the
DISPLAY
button which will always override the
default LCD brightness setting.
Setup Input Page 2
The
SETUP
/
INP
Page 2
section contains the sub menus shown in figure 40.
Figure 40 - Menu Map of SETUP/INP Page 2
To access this page, from either
INPUT SELECT
page or any other function menu, press
SETUP
then
INP
(input),
then the
A-D
button once. Page 2 of the
SETUP
/
INP
menu is shown in figure 41.
Figure 41 - Front Panel Display of the SETUP
/
INP
Page 2 Sub Menu
LFE Phase
The
LFE
phase can be changed from
+
(in phase) to
–
(180 degrees out of phase). This can be edited via button #
1
and is applicable for the currently selected input.
Summary of Contents for Casablanca II
