Theta Digital Casablanca II, Owner'S Manual

Page: 123 / 125

Specifications subject to change without notice. 113
Standard Quality 6 Channel Single-Ended D/A Output Card
Outputs:
Each single-ended DAC card can be assigned one of the following output configurations:
-Front Left, Front Right, Front Center, Surround Left, Surround Right, Sub 1.
-Side Left, Side Right, Sub 2, Sub 3, Sub 4, Sub 5.
-Side Left, Side Right, Surround Center, Sub 2, Sub 3, Sub 4.
-Surround Left, Surround Right, Sub 1, Sub 2, Sub 3, Sub 4.
-Surround Left, Surround Right, Surround Center, Side Left, Side Right, Sub 1.
-Surround left, Surround right, Side left, Side right, Sub 1, Sub 2.
D/A Conversion: 18 bit Delta-Sigma, one stereo DAC per channel producing plus and minus phases.
There are 3 stereo DACs per board.
Digital Filter: 8x digital interpolation filter followed by a 64x delta-sigma modulator.
Volume Control: I.C. based, in the analog domain.
Single-Ended Outputs: One phase of balanced outputs, not summed.
Sample Rates Supported: 32KHz, 44.1 KHz, 48 KHz.
Output Specifications:
Output Impedance: 36.5 Ohms
Maximum Output Level: 10 Vrms
Frequency Response: 20 Hz-20 kHz,
±
0.2 dB, Ref. 1KHz.
THD+Noise: Less than 0.0060% @ 1KHz, maximum output level.
Dynamic Range: 95dB minimum, 20KHz bandwidth, Ref. 1KHZ, A-weighted.
Signal to Noise Ratio: 95 typical, idle channel, A-weighted.
Crosstalk: -90dB Right - Left, -120dB Center-Left @ 20KHz