Theta Digital Casablanca II, Owner'S Manual

Page: 58 / 125

48
SETUP Function
This function provides access to a series of sub menus that will allow the configuration of the entire system. In this
section, each feature of the
SETUP menu is discussed in detail along with a diagram of each LCD display.
Note: A complete step-by-step speaker configuration setup guide is located on page 15.
Pressing the SET-UP button once changes the front panel display to the first page of the SETUP menu, shown in figure
19.
Figure 19 - Front Panel Display of the SETUP Menu
As indicated in figure 19, button 1 is assigned to features that are stored by input and leads to a series of categorized
sub menus via 3 pages. Button # 2 accesses all submenus and parameters that are not programmable by input select
button, or in other words, global features. Button # 3 accesses the MACROS sub menu and button # 4 allows the user
to password protect all SETUP features. Button # 5 displays the configuration of the installed DAC cards.
Setup Button Password
It is possible to password protect the entire SETUP function, or have no password at all. If a password is set here, the
user will be asked to enter the 5 digit password whenever the SETUP function is accessed. Setting a password for the
SETUP button is accessed by pressing button # 4 , where the user will be asked “ ARE YOU SURE? ” Answering “ YES ”
by pressing button # 2 will display the following page:
Figure 20 - Front Panel Display of the SETUP / Assign Password Display
Use buttons 1 - 6 to assign a password. After each digit is entered, the cursor (flashing in the Onscreen Display (OSD)
only, not the LCD) moves one character to the right. If no password is to be used (factory default), press the A-D
button five times, which enters all zeros. All zeros, or a zero anywhere in the password translates to no password.
CAUTION : It is imperative that your new password be written down. If it is forgotten, ALL access to the SETUP menu
will be permanently denied. Please see the WARNING on page 14.
DAC Configuration
Pressing button # 5 allows the user to view the channels assigned to each DAC card. This is an information page only
and not an editable menu. As an example, the first page will say “ LEFT FRONT CEN ” if a three channel balanced
DAC card is in DAC slot # 1. Press the A-D button to view which channels are assigned to the second DAC card, and
A-D once more for the third DAC card, if any. Press SET-UP once to exit this menu.
The following section will discuss all menus and parameters under the INPUT button.