Theta Digital Casablanca II, Owner'S Manual

Page: 102 / 125

92
Setup Input Page 3
This is the third page of the SETUP / ACTIVE INPUT SETTINGS menu.
It allows editing of the active input name via the MISC menu, setting a
master audio delay, setting a password for each INPUT SELECT
button, enabling/disabling Auto-Search and setting the Center Spread
parameter. All of these features are discussed below.
Figure 92 - Video Display of the SETUP / INPUT Page 3 Sub Menu
Setup Miscellaneous
Press button # 1 to enter the MISC sub menu.
Naming the Current Input Select button
Select the input to rename. Then press SETUP , ACTIVE INPUT SETTINGS , A-D twice, MISC and button # 1 to
name the currently selected input. The letters LCD or OSD will be displayed in the lower portion of the display. LCD
indicates that the name in the LCD is to be edited. LCD names are limited to 4 characters. Press the LEVEL
UP / DOWN button to change characters and the LEVEL LEFT / RIGHT to change character positions. Pressing the
DISPLAY button once will clear the current INPUT SELECT name. Press the A-D button to edit the OSD name.
OSD will appear in the lower portion of the display. This name can be up to 15 characters and the current character
to be edited will blink on screen.
Press SETUP once to return to the SETUP / INP page 3 submenu.
Master Delay
When video processing occurs, there can sometimes be a delay in the output of the video signal. Each process may
be only 1 to 2 frames out of sync, however, each can add up to a significant enough amount to where the audio and
video are not in sync. If this happens, the Casablanca II allows the user to set an overall, or master delay on all
outputs simultaneously in order to re-sync the audio with the video signal. In the
SETUP
/
ACTIVE INPUT SETTINGS
page 3 submenu, press button # 2 and use the LEVEL UP / DOWN buttons to adjust the audio delay time until the
video appears to be in sync with the audio. The range is 0 to 110 mS at 48KHz.
When complete, press SETUP twice to return to the INPUT SELECT menu.
Password for Each INPUT SELECT Button
Press button # 3 to set a password for the currently selected input. Entering a password here will prompt the user to
type in the password each time he/she wishes to change configuration settings for this INPUT SELECT .
When the PW button is pressed, an “ ARE YOU SURE YOU WANT TO ENTER A PASSWORD FOR THIS MENU? ”
message appears on the screen. Pressing NO (button # 6 ) reverts back to the SETUP / INP Page 3 submenu.
Pressing YES ( A-D button) will display a screen that allows a password to be entered, with the first character blinking.
The user can use buttons 1 - 6 to enter a password, or elect to have no password for this INPUT SELECT button by
pressing the A-D button 5 times, which will display all zeros, indicating no password.
Note : If a zero appears in any position of the password, it will be seen as all zeros, or no password. PLEASE
REMEMBER and/or WRITE DOWN YOUR PASSWORD! If it is forgotten, all access to password protected areas
will be denied! There is no other over ride to this feature. Please refer to page 14 for additional information on using
passwords.
Auto-Search Master Control
Pressing button # 4 will enable/disable the Auto-Search feature for the currently selected input only. Please refer to
page 40 for details of the Auto-Search feature.
Center Spread
This parameter adjusts the mix between the center speaker and the front left/right speakers. This effect is a post
process to all other digital signal processing and is therefore activated in the
POST PROCESS sub menu. The higher