Thermo Scientific Sorvall ST Plus Series, Instructions For Use Manual

Page: 60 / 172

3-28
Graphical User Interface
Figure 3–52: Programs -> Import Programs Pop-up Window with Progress Bar
NOTICE
You may abort a running import at any time by tapping the Cancel button in the Import Programs
pop-up window. If you do so, the import is aborted, and the Import Error message appears. This message
lists all programs that have not been imported successfully.
NOTICE While the import is running, make sure you do not remove the USB drive from the USB port. If
you remove the USB drive , the import is aborted, and the Import Error message appears. This message
lists all programs that have not been imported successfully.
NOTICE
While the import is running, the centrifuge may run out of memory when the maximum
supported number of programs is exceeded. If that happens, the import is aborted, and the Import
Error message appears. Repeat the import with fewer programs selected or delete programs from the
centrifuge (see
“Deleting a Program” on page 3-24 ) and repeat the import for the programs that were
not imported.
NOTICE While the import is running, the centrifuge may encounter duplicate entries that bear the
same name as existing programs. If that happens, the import is aborted, and the Import Error message
appears. To resolve this conflict, tap the Overwrite button to allow the imported program to replace an
existing program of the same name. Alternatively, you may tap the Skip button to retain the existing
program stored on the centrifuge, rename the existing program, then repeat the import.
NOTICE
While the import is running, the centrifuge verifies the programs being imported and discards
any corrupted programs that will not run. If that happens, the import is aborted, and the Import Error
message appears.
6. When the import has been successfully completed, the “Import Complete” pop-up window shown in Figure
3–53 below appears.
Figure 3–53: Programs -> Import Complete Pop-up Window
7. Tap the OK button to acknowledge the message and remove the USB drive.
The imported programs are now ready for use.