Thermo Scientific Shake 'n Stack 6244, Operating And Maintenance Manual

Page: 15 / 92

3-2 Shake ‘n Stack Thermo Scientific
Section 3
Set Up the Shaking Platform
3. Slide drive arm assembly sleeve onto
rotisserie drive shaft, aligning
location peg within drive arm sleeve
into either slot on drive shaft,
ensuring the sleeve is pushed fully
onto shaft. Tighten using thumb
screw.
4. Locate front left peg of tray into
the hole at the end of the drive
arm.
5. Slide the rear left peg into the
horizontal slot on the left-hand side
of bracket at the back of oven.
Assembly is now complete and
ready to operate.
Figure 4. Slide Sleeve onto Shaft
Figure 5. Tray Peg into Arm Hole
Figure 6. Rear Peg into Slot