Thermo Scientific Shake 'n Stack 6244, Operating And Maintenance Manual

Page: 14 / 92

Section 3
Set Up the Shaking Platform
1. The shaker bracket is installed at the
factory. If replacement should ever
become necessary, instructions follow.
Continue to Step 2.
• Loosen existing screws at the bottom
of the oven back sufficiently to allow
slots in bracket to slide down onto
screw shafts. Retighten screws to
secure back plate. See Figure 2.
2. Fit the rear right hand peg of tray into
vertical slot at right of bracket,
allowing tray to temporarily rest on
oven base. Refer to Figure 3.
Shake ‘n Stack 3-1 Thermo Scientific
Figure 3. Insert Tray Peg into Slot
Figure 2. Replace Shaker Bracket
Drive shaft
screw
Slot
Drive Arm
Assembly Sleeve
Fan
Oven back
Bracket
Shaker peg
Oven base
Shaker tray
Rotisserie drive shaft
Location
peg
Thumb
screw
Screw
Drive arm
Shaker peg
Figure 1. Shaking Tray Components