Thermo Scientific Mercury Freedom 80i, Manual

Page: 73 / 104

Optional Equipment
Hydrator
Thermo Fisher Scientific Mercury System Manual 6-3
Use the following procedure to mount the Hydrator on the rack exterior.
1. Mount Hydrator assembly at the rear of the instrument rack on the
panel provided. Keep in mind the unit will be mounted in the upright
position as shown in
Figure 6–2 . Use appropriate length 1/4 -20
stainless steel hardware to mount the assembly to the panel.
Figure 6–2. Hydrator Mounted Inside Rack
2. Connect the modular eight-pin connector to the Hydrator bulkhead
connector located at the top left of the unit when viewed from the
front. Run this cable to the rear of the 80
i , utilizing the available
Panduit tray, and leave an adequate “service loop” at the rear of the 80 i
to facilitate sliding the instrument out of the rack.
Use the following procedure to retrofit the Hydrator on a fielded Mercury
System.
1. Determine Hydrator location.
When selecting a location, the primary determining factor should be
ease of plumbing the assembly and the available lengths of required
tubing prior to operation. Carefully evaluate likely locations and
determine the best overall fit.
Equipment Installation on
Rack Interior
Retrofit Instructions For
Fielded Mercury Systems