Thermo Scientific iEMS Incubator, User Manual

Page: 24 / 66

Chapter 6: Operation
Thermo Scientific iEMS Incubator / Shaker HT User Manual Rev. 2.4, Cat. no. 1506400A 21
Program the incubation time by dialing the number keys: first hours; then
minutes, and finally seconds.
Note: Check where the cursor (underline) is located before you enter a value.
The value will be entered at the location of the cursor.
For example, for an incubation time of 1 hour 30 minutes:
Press
01 30 00 ↵
Note:
If you want to interrupt the programming, press
stop
to return to the
READY state. Your changes will be saved.
Program the shaking time by dialing the number keys: first seconds; then
hours, and finally minutes.
Note: Check where the cursor (underline) is located before you enter a value.
The value will be entered at the location of the cursor.
For example, for a shaking time of 20 seconds:
Press
00 00 20
↵
Note:
If you want to interrupt programming, press
stop
to return to the
READY state. Your changes will be saved.
Interval time is a programmable parameter that allows you to specify at what
interval the shaking is alternately switched off and on (for example, an interval
time of 00:00:10 results in 10 seconds of shaking turned on, 10 seconds of
shaking turned off, 10 seconds of shaking turned on, etc.) for the duration of the
programmed shaking time.
Program the interval shaking time by dialing the number keys: first minutes;
then seconds, and finally hours.
Note: Check where the cursor (underline) is located before you enter a value.
The value will be entered at the location of the cursor.
For example, for an interval shaking time of zero:
Press
00 00 ↵
(Enter)
INC TIME 01:30:00
SHAKE TIME 00:00:00
SHAKE TIME 00:00:20
INT TIME 00:00:00
SHAKE TIME 00:00:20
INT TIME 00:00:00