Thermo Scientific iEMS Incubator, User Manual

Page: 20 / 66

Chapter 5: Installation
Thermo Scientific iEMS Incubator / Shaker HT User Manual Rev. 2.4, Cat. no. 1506400A 17
3. Remove the voltage selector module (Fig. 5.2, item 4), rotate it 180° and
replace. Make sure the correct voltage value is visible through the slit at the
end of the voltage selector/fuse block assembly (Fig. 5.2, item 3).
1. Fuse
2. Fuse holder
3. Slit showing the correct voltage
4. Voltage selector module
Fig. 5.2 Selecting the correct voltage
4. Slide the fuse block assembly back into the power entry port housing. Snap
the assembly securely into place.
5. Reinsert the power cable.
5.3.2 Mains supply cable
Warning: Never operate your instrument from a power outlet that has no ground
connection. Never use a mains supply cable other than the Thermo
Scientific mains supply cable designed for your region.
1.
Ensure the mains switch (Fig. 4.1, item 7) at the back of the left side panel is
in the
OFF position.
2. Connect the mains supply cable to the mains input socket (Fig. 4.1, item 6)
at the back of the left side panel.
3. Connect the instrument to a correctly installed line power outlet that has a
protective conductor that is grounded.
2
3
4
1