77210163GB Issue 3
34
USE ThE CORRECT BLADE TYPE fOR ThE
BLADE hOLDER - EIThER LOw OR hIGh
PROfILE
3.6.5 TO SET UP ThE KNIfE hOLDER AND ANTI-
ROLL PLATE fOR DISPOSABLE BLADES
Note
1 These are the recommended settings. You may need
further minor adjustments to obtain best results.
Make sure that the top edge of the glass plate is parallel
to the knife. If adjustment is necessary, use a 3mm A/F
Allen key to loosen the two screws that hold the assembly
together.
Move the glass plate carefully until the top edge is parallel
to the knife. Hold the glass plate firmly in position and
tighten up the two screws.
Use the Height Adjust Control (a) to set the height of the
Anti-Roll Plate relative to the knife edge. Once adjusted,
further movement should not be required.
Note
1 This is a very fine adjustment. If it is set too low,
sections will curl above the Anti-Roll Plate. If it is
set too high, the block will foul the Anti-Roll Plate.
When cutting sections, lower the Anti-Roll Plate carefully
into position on the knife blade - do not let it drop onto the
blade. Any damage to the edge of the glass will result in
loss of performance.
a
Summary of Contents for Cryotome
Page 72: ...77210163GB Issue 3 72 ...
