Thermo Scientific Agilent 1200 Series, Getting Connected Manual

Page: 38 / 58

3
Setting Up the Thermo Foundation Instrument Configuration
Configuring the Agilent LC System’s Modules
26 Agilent 1200 Series Getting Connected Guide for LC Devices Thermo Scientific
• In the Stack IP Address box, make sure that the IP address is 172.16.0.102 .
• In the Module Name list, select the model number located on the front, lower-right
corner of the module.
3. Click OK .
Configuring the Agilent 1200 Series Detector
Use the DAD instrument configuration window to specify the detector model number. When
applicable, you can also specify the detector as having the contact interface board installed.
 To specify the configuration options for the detector
1. Follow the procedure “To add the LC modules to the Foundation instrument
configuration” on page 20 .
2. In the Instrument Configuration window, under Configured Devices, double-click the
detector icon, and then do the following on the General page ( Figure 21 ):
• If you installed the contact interface board in the detector, select the Contact Board
Installed check box.
• In the Stack IP Address box, make sure that the IP address is 172.16.0.102 .
\
Note All Agilent LC modules in the stack share the TCP/IP settings. Changing
the value of a setting for one module in the Instrument Configuration window
changes the value of that setting for all modules in the stack.
Note
• When you select the Contact Board Installed check box, the Timed Events
page appears in the Instrument Setup view for the detector. See Chapter 6,
“Triggering Data Acquisition.”
• You cannot install the external contact interface board in Model G1315C or
G1315D of the Agilent 1200 Series DAD.
Note All modules in the Agilent LC stack share the TCP/IP settings. Changing
the value of a setting for one module in the Instrument Configuration window
changes the value of that setting for all modules in the stack.