![background image](http://html1.mh-extra.com/html/thermo-king/tripac/tripac_operators-manual_1104341021.webp)
Unit Description
17
Engine Reset Switch
The engine is protected by a reset switch. When the reset
switch opens the engine will shut down and an “Eng” Alarm
Code will be displayed on the HMI. Typical causes for an open
engine reset switch are low oil pressure, high water
temperature or an engine start failure. The engine reset switch
is located on the side of the Interface Board control box
enclosure.
Closed Loop Cooling Option
The CLC option is designed for warm climate operation and
also to isolate the TriPac system from the tractor engine
coolant if desired. The TriPac will run independently of the
tractor engine coolant while providing battery charging and
cab comfort options.
On units with Interface Board
Revision 1.5 and earlier, the
button on the engine reset switch
pops out when the switch opens.
You can also feel it click and stay
in when you push it to reset it.
On units with Interface Board
Revision 1.6, the reset switch
button does not pop out when the
reset circuit opens. Also, you will
not feel a click when you push
the button to reset the circuit.
Figure 10: Engine Reset Switch
AMA618
1.
Coolant Tank
2.
Coolant Tank Sight Glass
Figure 11: Closed Loop Cooling Option
AMA783
1
2
Summary of Contents for TriPac
