![background image](http://html1.mh-extra.com/html/thermo-king/tripac/tripac_operators-manual_1104341031.webp)
TriPac HMI Controller Description and Operation
27
Engine On/Off Switch
The Engine On/Off Switch is located inside the TriPac APU
housing on the right side of the frame. This switch must be in
the On position for the TriPac engine to operate.
Figure 13: Engine On/Off Switch
DANGER: Always turn the TriPac Main Power
On/Off Key on the HMI Controller OFF while
refueling the truck. Fuel vapors could ignite if they
come in contact with TriPac electrical or heater
components.
WARNING: The unit may start automatically without
warning if the Engine On/Off Switch is in the On
position.
WARNING: Immediately stand clear when the
preheat buzzer sounds. This indicates that the engine
is preheating. If the engine is hot, preheat time will
only be a few seconds.
Use Tier 2 Photo
AMA695
Summary of Contents for TriPac
