Navigating the Controller Menus
40
Standard Display
The Standard Display shows the output voltage. It
appears approximately one minute after the last
key is pressed while the unit is running. The
Standard Display floats within the display to
prevent burn in.
Press the
E
NTER
key or the
E
SCAPE
key at the
Standard Display to enter the Main Menu.
Figure 13: Standard Display and Main Menu
Pause Mode Displays
A Pause mode display appears when normal unit
operation has been interrupted because of a
warning or alarm. The display will show the cause
and controller action. For example, the following
display appears if the engine fails to start.
Figure 14: Typical Pause Mode Display
Network Down Display
The Network Down display indicates there is no
communication between the SG+ controller and
the display. This is typically caused by a defective
SG+ controller, a defective display, a defective
cable, or a bad connection on the cable between
the SG+ controller and the display.
The Network Down display also appears when
software is be flash loaded into the controller.
Figure 15: Network Down Display
DATA \
ALARM LIST
MESSAGE LIST
COMMANDS
MISC. FUNCTIONS
CONFIGURATION
EVENT LOG
OUTPUT 460 V
Standard Display
Main Menu
WARNING: The AC alternator output or
engine may start at any time without
notice when the unit is in a PAUSE mode.
ENGINE FAILED
TO START
RESTART IN 20 MIN.
NETWORK DOWN
Summary of Contents for SGCO 3000
