![background image](http://html1.mh-extra.com/html/thermo-king/sgco-3000/sgco-3000_manual_1104399102.webp)
Engine Maintenance
102
11. Reconnect the main wire harness connector to
the fuel solenoid connector.
12. Connect wire 8S to the starter solenoid.
Fuel Solenoid Replacement
1. Disconnect wire 8S from the starter solenoid.
2. Disconnect the fuel solenoid wire connector.
3. Remove the old fuel solenoid.
4. Connect the main harness connector to the
new fuel solenoid.
5. Place the Unit On/Off switch in the “ON”
position to energize the fuel solenoid.
NOTE: The fuel solenoid must be energized
when it is being installed. If it is not, the plunger
and the linkage may not line up correctly.
6. Place the O-ring in the groove in the end of
the fuel injection pump. Make sure that the
O-ring is positioned correctly during
installation to avoid damage and leaks.
7. Install the new fuel solenoid.
8. Turn the unit Off.
9. Connect wire 8S to the starter solenoid.
1.
Integral Fuel Solenoid
2.
O-ring
3.
Fuel Injection Pump Groove
Figure 65: Integral Fuel Solenoid Components
AXA0298
Summary of Contents for SGCO 3000
