OPERATOR CONTROLS
22
MANUAL 430429-490
24V Circuit Breaker –
Push to reset. Controls 24V power
source for wire feeders controlled through 14-Pin receptacle.
115V Circuit Breaker –
Push to reset. Controls 115V power
source for wire feeders controlled through 14-Pin receptacle.
Primary Power Switch -
Placing the Primary Power Switch
(circuit breaker) located on the rear panel to the ON position
energizes the welding power source.
Voltage Selector –
Manual slide switch selects the proper input
voltage range. If this slide switch is not set to the position that
matches the input voltage from the electrical source, the Smart
Logic will inhibit welding power source turn on and the
corresponding warning message will be displayed.
Input Cable -
10 feet
Figure 5. Rear panel operator controls
