Themis RES-12XR3-S, Installation Manual

Page: 61 / 138

Installation and Operation
Operation
2-17
Themis Computer
2.2.2 Rack-Mount Slides (Optional)
Rack-Mount Slides can be mounted on each side of the RES-12XR3-S for X8DAL-
3/i, for the purpose of sliding the unit in and out of a rack. Mounting slides are
optional and should be ordered at the time your system is purchased.
To learn how to install rack-mount slides, refer to Appendix B, “Rack-Mount Slide
Installation”.
2.3 Operation
2.3.1 Plugging in the AC Power Cords
Before powering on the RES-12XR3-S, plug in the AC power cords as follows:
1. On the rear of the RES-12XR3-S, plug an AC power cord (shipped with unit)
into the AC power socket on each power supply (see
Figure 2-14 ).
2.3.2 Turning the System On
1. Plug the AC power cord from each of the RES-12XR3-S for X8DAL-3/i pow-
er supplies into a “live” AC outlet.
The LED on each power supply will turn on when AC power is enabled.
Caution: Any screws used to mount a slide to a RES-12XR3-S chassis must not
exceed a length of 3/8” to prevent excessive penetration of the chassis.
Figure 2-14. AC Power Socket and LED on the RES-12XR3-S for X8DAL-3/i Rear
AC Power Socket
Power LED
Locking Lever