PROVIDENCE INSERT
PELLET STOVE
27
BATTERY BACKUP OPERATION
The PROVIDENCE Fireplace Insert is equipped
with battery backup technology. To utilize this
feature you will have to purchase the optional 12V
battery cable and a sealed 12V battery. Your dealer
should have these items in stock and if not, please
call the factory. To hook up the battery and engage
the 12V backup system, do the following:
A.
Place sealed 12V battery at least one foot
from stove but not more than four feet from
stove (length of cable).
B.
Connect the red battery cable (+) to the
positive terminal on the battery.
C.
Connect the black battery cable (-) to the
negative side of the battery.
AFTER PLUGGING IN THE AC LINE CORD,
THEN PLUG THE TWO BANANA PLUGS
(RED AND BLACK) INTO THE
WARNING
Make sure the red cable goes to the red terminal and the
black cable goes to the black terminal. If you hook these
up correctly the BATT light will glow green. If you
hook them up backward the BATT light will glow red
and the backup will not work. DO NOT let the battery
terminals touch stove. Failure to install correctly could
cause physical harm and short out circuit board and will
void the warranty on the heater.
When the battery is properly connected the
following will happen automatically:
A.
If the heater is running and there is a power
failure, it will automatically switch to
battery power. (It happens instantaneously
and you will not even notice it.)
B.
When power is restored, the stove will
switch back to AC power automatically
AND trickle-charge the battery. As long as
the stove is plugged into the wall outlet it
will keep the battery charged. If you unplug
the stove during the summer and leave the
battery attached, it will run down the battery
and shorten its life.
C.
Run time on the battery will depend upon
the amperage of the battery. See your local
battery store outlet for details.
D.
If you wish to place the battery eight, ten, or
twelve feet from the stove you will need to
increase the wire size of the cable. Check
with your local electrical professional to
make sure you have used the proper gauge
wire/cable.
E.
The automatic ignition feature will not work
on the battery mode. If the stove is off and
the power fails, you will have to light the
stove manually with an approved fire starter.
WARNING
Summary of Contents for providence
