6-5
User Manual PN 84469 Rev L
SYSTEM RESETS
In a rare situation where the VesseLINK
™
system is not responding or operating properly, it may
be necessary to reset the system. There are varying levels of system resets that are explained
below:
Power Cycle
There are three (3) ways to power cycle the system:
If power is already on (LEDs are illuminated), press and hold the Power Button on the
unit until the unit turns off. Again, press and release the Power Button to power the unit
on. It will take a few minutes before the boot-up cycle completes.
Figure 6-1 Location of Power Button on BDU
From the Management Portal, select SYSTEM
RESET
REBOOT DEVICE. Press
REBOOT. It will take a few minutes before the boot-up cycle completes.
Figure 6-2 Management Portal - SYSTEM
RESET
If neither of these work, then unplugging the system from the power source may be
necessary. Note: Always wait at least 20 seconds for power inside the unit to dissipate
before reconnecting the input power.
Summary of Contents for VesseLINK Certus 200
