en-66
7 OPERATION
7.12 TRANSPORTING ______________________________________________________
Transport speed is for highway use only. Never select transport speed or 2 wheel drive off road. Transport in 2
wheel drive only. Make sure that the cutting units are held in the lifted position with the safety catches
engaged.
1.
Start the engine and set the throttle lever to full speed position.
2.
Release the parking brake and after ensuring that the pedal control lever is in the transport position, press
the upper part of the foot pedal. The machine will move in a forward direction.
3. Continue to push down on the foot until the desired speed of the machine is reached.The foot should always
be kept firmly on the pedal to maintain full control of the drive pedal.
7.12.1 TRANSPORTING ON A TRAILER OR FLATBED ___________________________
The machine has hard-point tie-down loops front
(A) and rear (B). Fasten the mower to the
transport vehicle.
Make sure that all tie down straps are tight. Make
sure that the decks are locked in the transport
position. Check the fuel and hydraulic tank caps
are tight. Make sure that no part of the mower can
fall during transport.
Always follow the given maximum transport load
weight for the vehicle used.
Do Not carry more than the maximum weight
shown on the transport vehicle plate.
Slinging
When slinging the mower,
damage free clamps must be used, see the illustration,
with an approved lift frame. Information is available at www.tipnlift.co.uk.
Jacking
The machine jack points indicated by the decal shown.Two for each axle on four
wheel vehicles. Other axle types are different, check the Safety and Operations
Manual for the safe jack points
Summary of Contents for Jacobsen Ransomes Parkway 3 Meteor LGNN344
