en-64
7 OPERATION
7.8
DRIVING ____________________________________________________________
•
Release brake - Make sure the parking brake is
released before attempting to go forward or
reverse.
•
Forward - Gently depress the top A of the FWD/
REV foot pedal to reach desired ground speed.
•
Reverse - Gently depress the bottom B of the
FWD/REV foot pedal to reach desired ground
speed.
•
To stop - Gently return the FWD/REV foot pedal
to the neutral position.
•
To hold the vehicle stationary on a slope it may be
necessary to apply a certain amount of either
forward or reverse traction.
NOTES:
•
Use the complete foot to operate both forward and reverse.
•
Do not move pedal suddenly–always operate slowly and smoothly. Do Not move pedal violently from
forward to reverse or vice versa.
7.9
MOWING_____________________________________________________________
1.
Release the transport latches (A) and lower the
cutting units with the joysticks.
2.
Ensure speed limiter is in mow position. (Cutting
at a higher speed could be dangerous and may
not give the required finish.)
3.
Engage the cutting mechanism by pushing on the
lower half of cutting unit switch.
4.
Release the parking brake and begin driving
forward.
5.
If the mower is used with the optional stability
warning system a warning will be displayed on the
visual display unit on the control panel should the
mower be driven on a slope exceeding its safe limit. a
t
25º
the centre and upper unit will be raised 4"-
6” above the ground to improve stability and all units will stop rotating.
until the mower is moved to a
safe operating area.
NOTE: Always set the throttle to full engine revs. for mowing, even when the grass is heavy. When the engine is
laboring, reduce forward speed by easing back on the FWD/REV foot pedal.
A
A
A
B
Summary of Contents for Jacobsen Ransomes Parkway 3 Meteor LGNN344
