Textron Bob-Cat, Operator'S Manual

Page: 28 / 119

26
HYDRO
MIDSIZE
PARKING BRAKE (If equipped)
Apply the parking brake and try to move the machine
forward and back. If necessary adjust by turning the
swivel at end of lever to lengthen or shorten the parking
brake rod.
BLADE CONTROL ROD
The blade control rod (connected to blade control lever
at L.H. side of control panel) is correctly set when it
snaps over center and stays in the stop position when
the blades are disengaged. Adjust by turning swivel at
end of lever to lengthen or shorten blade control rod.
SPEED CONTROL SWITCH
ADJUSTMENTS
OPERATOR PRESENT CONTROLS
The operator present (OP) controls should be
adjusted to control the operation of the plunger of
switch E (located under the right side of the control
panel). Depressing OP levers F should depress the
plunger; releasing the levers should extend it.
TO ADJUST:
1. Loosen clamp bolts on both ends G so clamps
can rotate on shaft. Loosen clamp bolts H so OP
levers are free to move in clamps.
2. Hold OP levers to handles and adjust to fit.
Tighten bolts H.
3. Rotate actuator lever to depress switch plunger.
Keep OP levers against handles and tighten
bolts G.
4. When released, the OP levers should rise and
the actuator lever should rotate away from the
switch, allowing the switch plunger to extend
completely.
Adjust switch lever (L) so that plunger (N) in switch is
depressed when speed control lever is in neutral.
For proper operation the speed control switch lever (L)
should depress the plunger on the speed control
switch when the speed control is set to neutral. If it
does not, the switch lever should be bent so the
switch plunger is depressed when the speed control is
set in neutral.
BELT TENSION
BELT TENSION BELT TENSION BELT TENSION BELT TENSION
HANDLE BAR HEIGHT ADJUSTMENT
To adjust handle bar height: Remove bolts (A) and
loosen bolts (D) on each side of handlebars.
Raise or lower as required.
Readjust traction control rods, speed selector rods,
parking brake rod(if equipped with parking brake) and
blade control rod.