TEXIO PU100-7.5, Instruction Manual

Page: 63 / 74

53
Table 7-4: Current programming range
Model Minimum(A) Maximum(A)
PU6-100 000.00 100.00
PU8-90 000.00 900.00
PU12.5-60 000.00 60.000
PU20-38 00.00 38.000
PU30-25 00.000 25.000
PU40-19 00.000 19.000
PU60-12.5 00.000 12.500
PU80-9.5 00.000 9.500
PU100-7.5 00.000 7.500
PU150-5 00.000 5.000
PU300-2.5 0.000 2.500
PU600-1.3 0.000 1.300
NOTE
The power supply can accept values higher by 5% than
The table values, however it is not recommended to
Program the power supply over the rated values.
Table 7-6: OVP programming range Table 7-7: UVL programming range
7.7.6 Status control commands
Refer to section 7-8 for definition pf the registers.
# Command Description
1 STT? Reads the complete power supply status.
Returns ASCII characters representing the following data, separated by commas:
MV<actual (measured) voltage> PC<programmed (set) current>
PV<programmed (set) voltage > SR<status register, 2-digit hex>
MC<actual (measured) current> FR<fault register, 2-digit hex>
Example response: MV(45.201), PV(45), MC(4.3257), PC(10), SR(30), FR(00)
2 FLT? Reads Fault Conditional Register. Return 2-digit hex.
3 FENA Set Fault Enable Register using 2-digit hex.
4 FENA? Reads Fault Enable Register. Returns 2-digit hex.
5 FEVE? Reads Fault Event Register. Returns 2-digit hex. Clears bits of Fault Event Register.
6 STAT? Reads Status Conditional Register. Returns 2-digit hex.
7 SENA Set Status Enable Register using 2-digit hex.
8 SENA? Reads Status Enable Register. Returns 2-digit hex.
9 SEVE? Reads Status Event register. Returns 2-digit hex. Clears bits of Status Event resister.