TEXIO PU100-7.5, Instruction Manual

Page: 27 / 74

17
Fig.3-7: Load wires connection to the output connector
4. Loosen the chassis screw marked “A” halfway as shown in Fig.3-8.
5. Assemble the protective shield to the chassis and tighten the two screws to fix the shield to the
chassis (see Fig.3-8). Screws tightening torque:0. 50-0.59Nm (5.1-6.1kgf・cm).
Fig.3-8: Shield assembly
6. Tighten the wires to one of the shield sides using ty-wrap or equivalent. Refer to Fig.3-9.
Ensure that the wire length inside the shield is long enough to provide strain relief.
Fig.3-9: Protective shield and wires assembly