Tews Technologies TPMC682-10, User Manual

Page: 16 / 36

TPMC682 User Manual Issue 1.1 Page 16 of 36
4.2.5 Handshake Status and Control Register 0 (HSCR0; 0x13)
Bit Symbol Description Access
Reset
Value
7 FIFO_STATUS0 FIFO Status Flag
0 : FIFO level within threshold of FTHR0
1 : FIFO level exceeds threshold of FTHR0 R 0
6..5 PORT0_HS H2 Handshake Output Protocol
00 : None
10 : Interlocked Handshake Protocol
11 : Pulsed Handshake Protocol R/W 00
4 TOUT_STATUS0 Read Timeout Status Flag
0 : no Timeout Event
1 : active Timeout Event R/W 0
3 TOUT_EN0 Read Timeout Enable
0 : Read Timeout Counter halted
1 : Read Timeout Counter enabled R/W 0
2 - Reserved (‘0’ for reads) - 0
1 INT_EN0 Port 0 Interrupt Enable
0 : Interrupts disabled
1 : Interrupts enabled R/W 0
0 - Reserved (‘1’ for reads) - 1
Figure 4-7 : Handshake Status and Control Register 0 (HSCR0)
The Handshake Status and Control Register 0 controls 16 bit Handshake Port 0.
After the Timeout Counter is enabled, it is started with the first falling edge on H1.
When interrupts are enabled globally (bit 0 of IFCR is ‘1’) and for Port 0 (bit 1 is ‘1’), an interrupt
is generated when Timeout Status Flag is ‘1’ or FIFO Status Flag is ‘1’.
The Timeout Status Flag is acknowledged by writing ‘1’ to bit 4.