TESTO Saveris 2 H2, Commissioning Instructions

Page: 25 / 120

6 Commissioning
25

With the H2D/H4D Saveris radio data logger, the external humidity
probe must be plugged in.
3 Hold the connect key on the rear of the Saveris radio data logger
pressed down until the LED on the Saveris radio data logger starts to
flash orange.

The LED on the Saveris radio data logger briefly turns green when
this has been detected by the Saveris base.
The LED on the Saveris base briefly flashes green and a prompt to
register more Saveris radio data loggers or Saveris routers appears in
the display of the base.
It is not possible to register multiple Saveris radio data loggers on the
Saveris base at the same time. Multiple Saveris radio data loggers can
only be registered one after the other.
4 On the Saveris base,
4.1 Press the
[Esc]
key if there are no other components to be
registered.

Information about the necessary execution of the startup wizard
is shown on the display for about ten seconds. The Saveris
base then switches to the Info System menu where the
number of registered components is now displayed.
4.2 Press the [Enter] key if there is another component to be
registered; see previous step.