It is necessary to compact thread connections by plumbing sealant or PTFE-4 band GOST24222-80 (GOST –
national state standard).
Two types of tanks can be used for hot water with the stove «Tunguska»: «outboard» tank and «samovar» type.
An outboard tank is fixed on a wall of steam room or washing room in convenience place for a Consumer.
Then, it is connected to a heat transfer device through the use of pipeline (scheme of installation of a water heating
system, see point 9.10). Water in a tank is heated by its circulation through a heat-transfer.
A tank of «samovar» type is fixed on outlet branch pipe of the chimney. Water is heated by warm of outgoing
flue gases into the chimney.
When water starts to boil cold water shall be added into the tank.
Don't pour the water in tank up to the top because when water starts to boil it may spill over.
«Termofor» company recommends to use «Tunguska» bath stove along with tanks of «Termofor» trademark.
9.11. Hot water tank assembly
ATTENTION! Hot water tank is the unit of extra high hazard that is why it is necessary to exercise caution
while being near it.
ATTENTION! «Termofor» company is not responsible for improper fastening of the tank.
ATTENTION! Avoid corrosive substances entering the hot water tank and water heating system.
ATTENTION! It is prohibited to pour water into the empty tank and (or) fill in empty water heating system
(if any) after stove starting up until the full cooling off of the stove and the tank.
ATTENTION! To avoid injuries and burns it is necessary to provide maximum reliable fastening of the tank
to the wall.
ATTENTION! The wall at which the remote tank is installed shall support the weight of the tank fully filled
in with water.
ATTENTION! It is prohibited to misuse the tank.
ATTENTION! It is prohibited to use defective tank having visual damages and (or) leakages.
ATTENTION! It is prohibited to use the tank under excessive pressure that differs from the atmospheric
one.
ATTENTION! It is prohibited to touch the warmed up to high temperatures surfaces of the tank with bare
hands or with other parts of body in order to avoid burns and damages.
G
3
/
4
G
3
/
4
fitting of the
heat exchanger
heat exchanger
Tube with an internal
connecting thread
Figure 1
5
. Direct connection of
the pipeline
Figure 1
6
. Pipe connection
through coupling
G
3
/
4
G
3
/
4
Tube with an external
connecting thread
Plumbing coupling with internal
connecting thread
fitting of the heat
exchanger
heat exchanger
G
3
/
4
41
