Terex TS14G, Maintenance Manual

Page: 360 / 376

Section 300-0020
Miscellaneous - Lubrication System
6
SM 1889 Rev 2 12-05
Note - For temperature conversions to degrees
Fahrenheit (°F) refer to the table on page 11.
Note 1 - Consult your lubricant supplier for the correct
viscosity of lubricant to use when ambient
temperatures are consistently above or below those
listed.
Note 2 - Detroit Diesel does not recommend any
specific brand of engine oil but the use of oils that
meet API categories. Detroit Diesel recommends use
of only the multi-graded viscosity oils shown for the
various ambient temperatures listed.
Note 3 - Preheat is required below minimum
temperatures shown. Operation below the minimum
temperatures listed for the oil used without proper
preheat or warm-up results in greatly reduced
transmission life. Proper warm-up requires 20 minutes
minimum operation in neutral (with engine at part
throttle) before operating the transmission in gear.
Hydraulic Transmission Oil meeting Specification
EMS19058 may also conform to the Allison C-4
requirements. Consult your lubricant supplier for
confirmation.
RECOMMENDED LUBRICANTS
COMPONENT LUBRICANT VISCOSITY (See Note 1)
Engine Engine oil with 1.00% ash is recommended. The use of low viscosity oils, such as
Sulphated ash must not exceed 1.85% limit. 10W or 10W-30, can be used to aid in
starting the engine and providing
Classification is as follows: sufficient oil flow at ambient
API Classification CG-4 or CF-4 temperatures below -5°C (23°F).
Military Specifications MIL-L-2104E Continuous use of low viscosity oils can
SAE Grade 15W-40 decrease engine life due to wear.
Transmission Hydraulic Transmission Oil, Type C-4. Ambient Recommendation
See Note 3. -30° to 30° C SAE 0W-20 (Arctic)
-25° to 30° C DEXRON-III
-15° to 30° C SAE 10W
-10° to 30° C SAE 15W
-5° to 50° C SAE 30
0° to 50° C SAE 40
Differential, Multipurpose Extreme Pressure type gear oil SAE 80W-90
Planetary Gears, meeting MIL-L-2105C Specifications at ambient temperatures of -18° to 32°C
Power Takeoff, (No Zinc Additive).
Steering Gear
Grease Fittings Multipurpose Extreme Pressure Lithium Grease No. 2 Consistency
with a typical melting point of 190° C.
Cooling System Antifreeze, Ethylene Glycol
Fuel Tank Diesel Fuel Oil with maximum sulphur 0.5% DIN EN590
Hydraulic System Hydraulic Transmission Oil meeting MIL-L-2104C SAE 10W
Specifications or API Service Code CC or CD/SC at ambient temperatures of -18° to 32°C
Drivelines, Multipurpose Extreme Pressure Lithium Grease No. 2 Consistency
Steering Column (without 'Molybdenum'), with a typical melting
point of 190° C.
ENGINES AND TRANSMISSION
All information contained in the 'Lubrication and Service
Chart' was extracted from the relevant manufacturers
Operators Manual and was correct at time of
publication. User should ensure that information
contained in this chart, regarding the Engine and
Transmission, reflects the information shown in the
relevant manufacturers Operators Manuals, supplied
with the machine. Maintenance procedures should be
carried out in conjunction with any additional
procedures contained in the relevant manufacturers
'Operation and Maintenance Manual', at the intervals
specified.
Courtesy of Machine.Market