Terex TS14G, Maintenance Manual

Page: 232 / 376

Section 235-0040
Bowl Hydraulic System - Hydraulic Tank
SM 2279 04-04
4
filler cap (2) on filler neck assembly.
5. Place the battery master switch in the 'On'
position, remove wheel blocks, start the engine and
operate steering and bowl hydraulic systems to
circulate the hydraulic oil.
6. Switch off the engine and check for leaks. Tighten
lines and fittings as required. Check hydraulic oil tank
level as described under 'Checking Oil Level'.
SERVICE TOOLS
There are no special tools required for the
procedures outlined in this section. Refer to Section
300-0070, SERVICE TOOLS, for part numbers of
general service tools required. These tools are
available from your dealer.
Installation
Note:
Tighten all fasteners to standard torques listed in
Section 300-0080, STANDARD BOLT AND NUT
TORQUE SPECIFICATIONS.
Note:
Tighten all hydraulic lines fitted with ORFS
connections, as described in Section 235-0000,
HYDRAULIC SYSTEM SCHEMATIC.
WARNING
To prevent personal injury and property
damage, be sure lifting equipment is properly
secured and of adequate capacity to do the job
safely.
1. Using a suitable lifting device, position tank
assembly (1) carefully in position on the vehicle.
2. Secure tank assembly (1) to tank mounting brackets
with bolts (24), washers (25), lockwashers (26) and
nuts (27).
3. Install all lines and fittings to tank assembly (1) as
tagged at 'Removal'.
4. Remove filler cap (2) from filler neck assembly and
refill tank assembly (1) with hydraulic oil, as specified
in Section 300-0020, LUBRICATION SYSTEM. Install
* * * *
Courtesy of Machine.Market