RMX SERIES
-VII
R M X S e r i e s
T e r e x S o u t h D a k o t a
4 8 3 0 1 8 - 3 / 1 5
SA
FETY
1.
Never operate the Aerial Device unless you know the location, function, and operation of all the controls,
including emergency and accessory operation.
2.
Avoid abrupt starts, stops and reversal of direction. Operate all controls slowly for smooth motion.
3.
Keep hands off all moving parts to avoid injury.
4.
Operator(s) must wear an OSHA approved fall protection system with a lanyard attached to an anchor
provided.
5.
Wear personal protective equipment such as: Insulated hard hat, rubber gloves with leather protectors,
and rubber sleeves. Hearing and eye protection, proper boots and suitable clothing may also be
required.
6.
Do not place the boom in open traffic lanes, stop traffic or barricade lanes to divert traffic from area.
7.
Do not allow boom, platform, or any part of the Aerial Device to contact fixed objects.
8.
Do not tie off to an adjacent structure, pole, or other equipment.
9.
Never exceed rated capacity of platform for men, tools, and liner if equipped.
10. Do not pass tools, equipment, or other objects between the occupant of the platform and other
personnel on poles or other platforms.
11. Do not sit or climb onto edge of platform or use planks, ladders, or other devices for a work position.
Always stand with both feet on floor of the platform.
12. Do not wear climbers while in the platform.
13. Do not allow ground personnel under the platform work area.
14. Do not operate with platform leveling malfunctioning.
15. Do not move the vehicle with personnel in the platform.
16. Never tie loads to the platform or booms. Always use lifting attachment when it is necessary to lift or
lower an object.
17. Do not lift loads with the Aerial Device if it is not equipped with a lifting attachment.
18. High speed should only be used when moving the platform to an aerial job site. Low speed should be
used to move into, or within the aerial job site.
19. Low engine speed, if available, should be used when an extended period of time is going to be spent at
an aerial job site.
20. Do not use the platform for lifting material. The platform was designed for lifting personnel only.
21. If, when operating the Aerial Device, you become aware of any dangerous condition, unusual operation,
or hear any unusual noise, such as grinding, cracking, or grating sounds-STOP-in position. Do not move
the Aerial Device until the problem has been diagnosed and resolved with your safety in mind. No matter
how long it may take to get help, waiting is better than a serious or fatal accident.
22. Do not adjust outriggers while platform or booms are raised.
23. Do not operate boom controls while standing on the ground or other structures.
DURING OPERATION
