Terex Genie Z-45 DC, Service And Repair Manual, Page: 78 / 140

68 Z
®
-45 DC • Z
®
-45 FE Part No. 1297714GT
July 2020 Service and Repair Manual
Standard Genie fault codes shall be displayed and
the red LED will illuminate when any faults are
present. If more than one fault code is present, the
codes shall be displayed in succession with each
code displayed for 4 seconds. Once all active fault
codes have been displayed the screen will pause
for 4 seconds and then repeat the list of active
fault codes. Use the
Control Systems Fault Codes
chart to aid in troubleshooting the machine by
pinpointing the area or component affected.
The smart hour meter will display unit hours
and battery state of charge (SOC) whenever
no faults are present on the system. The value
will cycle between unit hours and battery SOC
every 5 seconds. When the engine is running (if
equipped), the display will cycle hours, SOC, and
RPM.
Both Engine Hours and DC Function Enable Hours
will be tracked. DC Function enable hours will
be displayed on the smart hour meter by default.
Engine Hours will be displayed if the hybrid mode
select switch is held for three (3) seconds. Engine
Hours will continue to display as long as the hybrid
mode select switch is held
1 LCD screen (8 character display)
2 Red LED below the wrench icon illuminates when
system faults are displayed
3 Yellow LED below the battery icon illuminates
when battery state of charge is displayed.
4 Green LED below the hourglass icon illuminates
when unit hours are displayed
Control System Fault Codes